What are the precautions for removing floor spring glass doors?
What should everyone pay attention to when dismantling glass doors. To determine whether your floor tension spring door is equipped with a solid door frame (or aluminum frame) or a glass clip, with a solid door frame accessory: open the door to a 90 degree positioning viewpoint, use something to support the lower corner of the handle opening end, one supporting the door, and the other adjusting the accessory screws on the top of the door with a screwdriver. Adjust the screws downwards, and the axis of the accessory will retract upwards to adjust the height to open the door.
When the ground spring body can be completely placed in the trench, the stabilization step of the ground spring body can be carried out, but cement can also be used, but the cement setting time is longer. Take out the ground spring body, add an appropriate amount of quick drying powder to the trench, mix with water until the viscosity is appropriate, and then place the ground spring body. Use a rubber hammer or wooden block, and then use a hammer to strike the ground spring to restore its surface to the surrounding ground level. Then use a plumb line to find the axis position of the ground spring and fine tune the ground spring body. This is a point that everyone needs to pay attention to.
The end of the service life of the ground spring is due to oil leakage and weakened elasticity of the axis. If the axis line between the sky axis and the ground spring spindle is not strictly perpendicular to the ground, the movement of the door leaf will bring large torque to the ground spring, increase wear between the spindle and bearings, and cause oil leakage of the axis. Springs inevitably weaken their elasticity after long-term stretching movements. In addition, everyone can also pay attention to this.
